ONE - STOP ELECTRONICS
AFTERMARKET SOLUTION

Bezel Glue Dispensing Machine
Nov 10th, 2014

A brand new Bezel Glue Dispensing Machine designed for Professional Solution is available now!

This cell phone broken LCD refurbishing machine is based on Hot Melt Glue and high temperature. Easy operation Intelligent program allows it to achieve volume production. And it comes with iPhone 4, 4s, 5, 5c, 5s, 6, 6 Plus, 6s, 6s Plus Molds.

Here is the main specification:
Voltage: 220V
Power: 800W
N.W.: 40KG
G.W.: 63KG
Dimension: 65x53x71cm
Working Environment: 20-30℃, Dust-free Room

As well as operation steps:
1. Connect to the air compressor and put bezel glue into the Heating Drum
2. Plug in and turn on
3. Establish the right program to the right series bezel
4. Temperature set 220℃(no higher than 280℃), pressure set 0.5Mpa
5. Place the bezel on the mold, then start the machine, it will finish by itself. (Note: Add one pc bezel glue after finsh 200 pcs bezel everytime; test the machine by checking whether glue dispensing is fluent or not).

Tips:
a. Test the machine by checking whether glue dispensing is fluent or not.
b. Hot Melt Glue should be added the second time after you have done a certain number of bezel frames(100-200pcs), so as to avoid the blockage of needle.


 

0.00 avg. rating (0% score) - 0 votes

Leave a Reply

Your email address will not be published.

COPYRIGHT © 2008-2017 REWA TECHNOLOGY CO., LTD. ALL RIGHTS RESERVED.
ONE - STOP ELECTRONICS AFTERMARKET SOLUTION